Edgewater Networks 318CC, Руководство для владельца

Страница: 195 / 213

3 Pro-Series & Pro-Fish Windlass
GB
Contents
Introduction 4
Product support 4
Approvals 4
Safety notices 4
General 4
Electrical 4
Electromagnetic compatibility 4
Important information about this manual 4
1. Installation 5
1.1 Gypsy suitability 5
1.2 Package contents 5
1.3 Additional requirements 5
1.4 Accessories 5
1.5 Specifi cations 5
1.6 Fitting the windlass to the deck 5
2. Electrical wiring installation 7
2.1 Electric cable selection 7
2.2 Wiring 7
2.3 Control Switch Installation 7
2.4 Model 700 - 12 V 8
2.5 Model 1000 - 12 V 9
3. Operating your windlass 10
3.1 Safety fi rst 10
3.2 Use of clutch on Pro-Series 10
3.3 Use of clutch on Pro-Fish freefall 10
3.4 Letting go under gravity 10
3.5 Letting go under power 10
3.6 Change Pro-Fish to power down mode 10
3.7 Lying to anchor safely 10
3.8 Hauling in 10
3.9 Manual recovery 10
3.10 Operating tips 10
3.11 Joining rope to chain 10
B10490 Issue 2. Pro-Series & Pro-Fish Windlass.
4. Maintenance 11
4.1 General recommendations 11
5. Dismantling procedures 11
5.1 Gypsy replacement (Pro-Series) 11
5.2 Gypsy replacement (Pro-Fish) 11
5.3 Control arm replacement 11
5.4 Gypsy drive shaft replacement &
lubrication service
11
5.5 Electric motor replacement 12
5.6 Pro-Fish conversion 12
6. Parts list 12
6.1 Parts list key Pro-Series & Pro-Fish
models 700 & 1000
12
6.2 Pro-Series & Pro-Fish models 700 & 1000
service kits
13
7. Troubleshooting 14
7.1 Anchor rode pays out independently
while windlass is not in use
14
7.2 Anchor rode pays out independently
while windlass not in use (Pro-Fish)
14
7.3 Electrical troubleshooting 14
8. Lewmar limited warranty 15
To the best of our knowledge, the information in this manual
was correct when it went to press. However, Lewmar cannot
accept liability for any inaccuracies or omissions it may contain.
In addition, our policy of continuous product improvement may
change specifi cations without notice. As a result, Lewmar cannot
accept liability for any differences between the product and the
manual.
This manual forms part of the product and MUST BE RETAINED
along with, OR incorporated into, the Owner’s Manual for the vessel
to which the windlass is fi tted.