Edgewater Networks 318CC, Руководство для владельца

Страница: 205 / 213

GB
Dimensions - inches (mm)
INSTALLATION INSTRUCTIONS
YOUR TOILET is just one part of a system.
Correct installation of the whole system is
essential if you want the toilet to perform
properly, operate reliably and safely, and give
satisfactory length of life.
The seat and lid is delivered boxed and unfitted
for its protection.
Key numbers, e.g. ('Key 31') are references to
the exploded view diagram on the back page.
Location
Select a location that will give sufficient
clearance all round and above the bowl.
The mounting surface must be flat, rigid and
strong enough to support a man's weight and
should be at least 2" (50mm) wider and 2"
(50mm) deeper than the base of the toilet.
You will need sufficient clearance below the
mounting surface to be able to secure the
mounting bolts, and to be able to remove them
for maintenance.
Offer up the seat and lid to the bowl. They
should be able to swing up and over, so that
they will not fall forward when the craft heels or
pitches. When they are swung over they must
be supported so that the hinges are not
strained. Remove the seat and lid and put them
aside until the installation is complete.
Mounting
YOU WILL need:
4 x 1¼” (6mm) diameter stainless steel bolts of
length to suit the thickness of the mounting
surface.
4 stainless steel nuts, preferably self-locking. If
you do not use self-locking nuts you will need
some nut-locking compound.
4 plastic and 4 stainless steel 1¼” (6mm)
washers
A tube of white silicone sealant.
Offer up the toilet in the selected position and,
using the holes in the base as a guide, mark
the positions for the 4 bolt holes on the
mounting surface. Remove the toilet and drill 4
vertical holes of
5 /
16
” (8mm) diameter through
the mounting surface.
Now complete all of the rest of the installation
before you secure the bowl.
Through Hull Fittings
YOU MAY need:
¾" 19mm bore seacock for the Rinse pump
and, if you are discharging the waste over
board, a 1½" 38mm bore seacock for the
waste outlet.
Follow the seacock manufacturer's own
instructions concerning materials and methods
of installation.
Ensure the inlet seacock is positioned where it
will be below the waterline at all times when the
craft is underway, and also ensure that any
other outlet seacock is both aft of, and higher
than, the inlet seacock.
HAZARD RISK : Through Hull fittings.
FOLLOW THESE INSTRUCTIONS!
If the installation of the toilet results in it
being connected to ANY through-hull
fitting that may possibly be below the waterline at
ANY time, whether when the craft is at rest,
underway and heeling or rolling or pitching, you
must install the toilet in accordance with these
Installation Instructions. If you do not, water may
flood in, causing the craft to sink, which may result
in loss of life.
HAZARD RISK: Accidental Damage.
USE SEACOCKS!
If the toilet is connected to ANY
through-hull fittings and if the toilet or
pipework is damaged, water may flood in causing
the craft to sink, which may result in loss of
life.Therefore, if you are making connections
between the toilet and ANY through-hull fittings
that may possibly be below the waterline at ANY
time, full bore seacocks must be fitted to those hull
fittings, to allow them to be shut off.
The seacocks MUST also be positioned where
they are easily accessible to all users of the toilet.
If, for any reason, it is not possible to do this, then
secondary bore marine quality valves MUST be
fitted to the hoses where they are easily
accessible.
* * *
* * *
* * *
3
14”
17”