1
Assembly of the
Side Handles
Assemble the oven handles:
Unbox/Uncrate
the Oven Compartment. Remove all the contents.
Attach the Lifting Handles as shown in this picture
using 4-(A) Flat Head Screws
No.
Name
Size
QTY
A
Flat Head Screw-1/2” Long M6*15 8 PCS
ECO-710
10
IMPORTANT!! Additional Tip for Attaching the Handles!!
Before you roll your new oven off the pallet, you need to attach the assembly handles. Each handle
was matched up to your oven when the main frame was dropped onto the base cart on the pallet.
It's important to have these handles fit tightly against the oven and the holes need to line up
straight to do that. The handles packed with your oven are a custom matched set for this oven.
They have been 100% inspected and assembled onto the oven at the factory- then removed and
packed inside. One is paired for the left side holes and one is paired for the right side holes. If you
try and assemble one of the handles to the right or left side and the holes don't line up, first flip the
handle over and try again on that side. Hold off tightening both handles down until both are in
place and fit properly on your oven. It's also possible that both handles will fit on either side, but
make sure that you have a match on both sides before tightening down the screws.
Also note that if the wire grid is in the way to attach the screws on the top of the handlebar
stamping, the wire grid can be adjusted slightly. It may have loosened up, shifted or dropped a
little during shipping. Simply loosen the screws a little and move it, then tighten the screws back
down once it's out of the way. It can also be completely removed, but that should not be necessary
for this assembly and it should
always
remain in place while the oven is operated for safety
reasons. The sides and back of the oven get very hot during use and the grid has been added to the
oven to prevent contact to the hot surface while in use.
It's also a great surface to hang your tools!
From time to time, please inspect the screws to make sure they are tight and re
-
tighten them as
necessary.
OCCASIONALLY INSPECT AND TIGHTEN SCREWS/BOLTS AS NECESSARY AFTER USE.
page|
5
