Firmware V6.6.9
29.07.2020
10/147
•
•
•
•
•
•
•
2.1 Exclusion of liability for non-observance
This operating manual contains information about the commissioning, function, operation and maintenance of
the controller and the associated components.
2.2 Requirements for the personnel
Special technical knowledge is required for planning, programming, installation, putting into service and
maintenance work. This work must only be performed by trained or specially trained personnel. The installation,
putting into service and maintenance personnel must have training which authorises interventions in the system
and the automation system. The planning and programming personnel must be familiar with the safety
concepts of automation technology. Specialist knowledge is required for work on electrical systems. Work on
electrical systems must only be carried out by qualified electricians or persons under their guidance or
supervision. In doing so, the respective applicable regulations (e.g. DIN EN 60204, EN 50178, BGV A3, DIN-
VDE 0100/0113) must be observed. The operating personnel must be instructed in handling the system /
machine and the controller and must be familiar with the operating instructions.
2.3 Intended Use
The controller is exclusively intended for the following use: T
he controllers in the CI 4000 series are intended
for use as system centre of the E*LDS system in commercial and industrial refrigeration systems and building
automation with the scope of functions and in accordance with the environmental conditions described in this
operating manual.
Note the safety instructions and the instructions for installation and start-up, operation and maintenance
. Start
the commissioning and/or operation of the machine / system AFTERWARDS.
The safety and the function of the machine / system are only fulfilled with this intended use.
Never use
the machine / system, its components, assemblies or parts for any other purpose.
The system must not
be put into operation until conformity with the applicable EU Directives has been established for the
entire installation.
2.4 Five safety rules according to BGV A3
The following rules
must be strictly observed
.
1. Disconnect: The entire system to be worked on must be disconnected from the power supply at all
poles.
2. Secure against restarting:
Attach information signs to the disconnected operating equipment stating:
What has been disconnected.
Reason for the disconnection.
Name of the person who made the disconnection.
Restarting must be prevented using a suitable lock (e.g. padlock).
3. Establish absence of voltage (only by authorised specialist personnel):
Check voltmeter just before use.
Establish absence of voltage on all poles at the disconnection point.
Establish absence of voltage on all poles at the place of work.
A basic requirement for safe and trouble-free operation is
compliance with this operating manual
.
Warning of dangerous electrical voltage!
Pay attention to possible external power supply!
BEFORE
connecting and disconnecting it must be checked that
no voltage is present
at the controller! All
device connections / connectors may only be plugged in, unplugged and/or wired when no voltage is
present.
Содержание CI 4000
Страница 143: ...Firmware V6 6 9 29 07 2020 143 147 ...
