English
English
7
Water supply hose
Do not use a water supply hose from and old appliance. Always use the new hose
supplied in the packaging. If the water pipes are new or have not been used for
a long time, first allow sufficient water to drain until completely clear water flows
out. Connect the water supply hose directly to the tap. The water supply pressure
must be a minimum of 0.03, MPA and a maximum of 1, MPA. If the water pressure
is higher than 1, MPA, a safety valve must be installed.
After connecting, the tap must be fully opened and checked for water leaks.
For safety reasons, switch off the water supply whenever you are not using the
dishwasher (after completing a program).
The supply hose is intended for cold water. Maximum temperature must not
exceed 25 °C.
Note:
Aquastop is used in some models. Dangerous stress can occur if the
Aquastop is used. Do not cut the drain opening. Do not allow this device
to bend.
Water drain hose
The water drain hose can be connected directly to the water drain or to the siphon. This
connection must be 50 ‑ 110 cm above floor level.
Warning:
Keep in mind that the hose must not be longer than 4 meters even with
an extension.
A longer drain hose would prevent proper functioning of the
dishwasher. In this case, our company is not responsible for the poor quality of
the washing result.
Electrical wiring
The grounded plug of your appliance must be connected to a grounded socket of suitable voltage. If there is
no grounding, have it done by a qualified electrician. If the appliance is connected to an ungrounded socket,
our company is not responsible for any problems that may occur. The plug of this appliance may contain
a 13 A fuse depending on the local regulations in force in each country.
Your appliance is set to 220 ‑ 240 V. Always disconnect the appliance from the power supply during handling.
Always use only the plug supplied with your appliance.
Starting at low voltage will degrade the quality of the washing. The power cord must be replaced by an
authorized service center or technician. Failure to follow these instructions may result in injury or damage
to the appliance. For safety reasons, always unplug the appliance after completing the washing program.
