English
English
19
Spray arms
Make sure that the nozzle openings are not blocked and
that no food residue or foreign objects remain on the
arms. If any of the nozzles became clogged, remove the
arm and clean it under running water. To remove the
upper spray arm, loosen the nut that holds it in place by
turning it clockwise and pulling it down. Make sure that
the nut is tight when reinstalling the upper arm.
Drain pump
Large food residues or foreign objects that have not been
caught by the filters can clog the waste water pump. The
rinsing water will then be above the filter.
Warning - risk of cuts!
When cleaning the drain pump, be careful not to cut
yourself on pieces of broken glass or pointed objects. In
this case;
1. First, disconnect the appliance from power.
2. Remove the baskets.
3. Remove the filters.
4. Remove water. Use a sponge if necessary.
5. Check the area and remove all foreign objects.
6. Install filters.
7. Insert baskets back.
AUTOMATIC ERROR MESSAGES AND THEIR SOLUTIONS
ERROR CODE
Error description
Probable cause/Solution
Wash
Exit
Start/
Suspension
Insufficient water
supply.
•
Make sure the water supply is
fully open.
•
Close the water supply,
disconnect the supply hose from
the tap, and clean the filter at the
hose connection.
•
If the error persists, restart the
dishwasher, contact service.
Water supply error
•
Close the taps.
•
Contact service
Waste water does
not drain from the
dishwasher.
•
Clogged water supply hose.
•
Your appliance’s filters might be
clogged.
•
Switch off the appliance and
activate the command to cancel
the program.
•
If the error persists, contact the
service center.
