Eccotemp CE-L5, Инструкция по установке, использованию и уходу

Страница: 20 / 39

Support: Support.Eccotemp.com Shop Online: eu.Eccotemp.com Store Locator: eu.Eccotemp.com/locator
20
EN
G
LI
SH
PLEASE NOTE: SH12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR THE MOST UP TO DATE WARRANTY AND MANUAL.
Only the 2.5”(6.3cm) vent kit provided with the Eccotemp SMART HOME SH12 or approved
stainless steel venting should be used for installation.
The wall thimble requires mechanical support from the wall sufficient to support any
thimble, then appropriate additional framing and/or blocking is required.
Installation Procedure:
Prepare an opening for the wall thimble in the wall. The opening must be 6-1/2 inches(16.5cm)
in diameter for a 3”(7.6cm) vent system. The opening should be round.
The opening must be able to accommodate the 3”(7.6cm) vent system and wall thimble
The wall thimble is designed to adapt to any wall thickness from 3-1/2” to 6”(15.2cm) thick.
6”(15.2cm) diameter snaplock or welded seam galvanized pipe up to 6”(15.2cm) long.
Select the larger diameter half of the wall thimble for the outside of the wall.
•
• Position this portion of the wall thimble into the prepared hole from the outside. Secure
the assembly into the prepared opening using fasteners as indicated by sheathing or
structural members, sealing the screw heads with more caulking.
Use 4 hollow wall anchors, at least 1/8”(.3cm) in diameter and of appropriate length for the
thickness of the sheathing, if sheathing is particle board or other composite material. Use 4
suitable masonry anchors when passing through solid masonry walls. Reinstall the decorative
• Slide the interior portion of the thimble into the inside hole. Be certain the interior and
interior portion with single wall galvanized pipe.
• Secure the vent section that protrudes through the wall thimble to the 90 degree elbow
attached to the water heater.
•
Venting
Installation
IN
ST
A
LL
AT
IO
N
CAUTION: Follow the vent manufacturers installation instructions as design might vary from
manufacturer to manufacturer.