CPX200N ALARM CONTROL UNIT – INSTALLER MANUAL
28 / 106
6.1.
ACTIVATION OF SERVICE MODE
To activate the service mode the installer code authorisation is required.
<Installer code>
3 beeps will confirm the correct input of the code and function number. PROG LED on will
inform that currently, the user is in service mode. When any service function is entered,
PROG LED will be blinking. After exit from the function, PROG LED will be lit constantly
again, informing that the user is in the main service mode menu.
6.2.
EXIT FROM SERVICE MODE
To exit the service mode press
and confirm with
. Using that function will trigger
the control unit’s reset using configured parameters.
The device will exit test mode automatically after 5 minutes without pressing the buttons
and system will restart.
6.3.
INSTALLER CODE
The installer code can be changed here. 3 beeps will confirm the successfully entered
function.
<Installer code>
<Installer code>
where:
Installer code –
new installer code (from 4 to 7 digits)
You can press
any time to exit without saving changes.
6.4.
POWER LOSS
The function determines time in seconds after which failure is to be reported. The function’s
argument is of decimal type. 3 beeps will confirm the successfully entered function.
To change /configure the time:
<Time>
where:
Time –
time in seconds
You can press
any time to exit without saving changes.
6.5.
RESET TO DEFAULT SETTINGS
That function resets the settings to their default configuration, accessible from the service
mode level. In order to protect the settings against accidental modification, the function is to
be additionally confirmed with installer code. 3 beeps will confirm the successfully entered
function. Using that function will trigger the control unit’s reset using default parameters.
<Installer code>
