Eaton UltraShift PLUS FO(M) E310C-LAS Series, Инструкция по эксплуатации

Страница: 8 / 44

3
Operation
Start-up and Power Down
Start-up
1. Turn the ignition key to “ON” and allow the UltraShift
®
PLUS to
power-up.
•
Engine cranking is delayed until the transmission power-up is
complete and the gear display shows a solid “N.”
2. Start the engine.
3. Apply service brake.
•
If the service brake is not applied while selecting a starting gear,
the initial start gear will not be found and the driver will have to
re-select Neutral and press the brake while re-selecting the
desired mode.
4. Select the desired mode and starting gear on the shift console.
Note: The transmission will over-ride inappropriate start gear selections to
avoid driveline damage.
5. Release the vehicle parking brakes.
6. Release service brake and apply accelerator.
Note: The Transmission Shift Console Mode Configuration determines clutch
operation during vehicle launch. (See page 10 for detailed information
regarding clutch engagement options and operation instructions).
Power Down
1. Select Neutral on the shift control.
•
If gear display does not show solid “N,” neutral has not yet been
obtained.
Note: Neutral should always be reached before the UltraShift PLUS power
down is performed except in cases of emergency.
2. Set the vehicle parking brakes.
3. Turn off the ignition key and allow the engine to shut down.