Eaton SC200, Руководство по эксплуатации

Страница: 69 / 139

System Operation
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
61
► To Characterize the Battery
1
Either:
Manually start a Characterization:
On the SC200 go to:
Battery > Characterize > Start .
Or, in DCTools/Web go to: Battery > Battery Time Remaining. Click Characterize .

If "Characterize" is not present on the SC200 or the "Characterize" button is inactive in
DCTools/Web, then check all configuration settings. In DCTools/Web, the hover text will
indicate why the characterization cannot start.
Or, use Automatic Characterization to start a characterization automatically when all
conditions are correct and stable :
In DCTools/Web go to: Battery > Battery Time Remaining.
Set Automatic Characterization to Enabled and set Automatic Characterization Delay to the
required time that the conditions must be stable.
2
The characterization process will take at least 10 hours, depending on the load current.

During characterization the rectifier output voltage is varied to maintain a constant power
discharge.
3
When the characterization has finished, the Characterization Result will be Updated .

If any other Characterization Result is shown, refer to BTR Operation on page 62 .
4
The rectifiers will return to float voltage and the battery will start to recharge. If required,
start a manual Equalize (see details on page
26 ) to reduce the battery recharge time.
5
Restore any changed LVD operation back to the original settings. If no longer required,
disable
Battery Current Limit .
Battery Time Remaining is now operational. During any battery discharge an estimate of time
remaining will be displayed.