Eaton Powerware Prestige Series 1500 VA, Инструкция по установке и эксплуатации

Страница: 87 / 102

Troubleshooting
75
Powerware
®
Prestige Series Installation and Operator’s Manual for IBM Applications (650 VA - 1500 VA) Uncontrolled Copy
Action Possible Cause Condition
BATTERY
Weak battery while in Normal
mode. The alarm beeps. Allow the battery to charge for 24 hours,
then retest. Have batteries replaced if
condition persists.
BATTERY
Battery breaker is open (O). Verify that the battery circuit breaker is in
the ON (
|
) position.
Battery cabinet is not properly
connected to the UPS. Verify that the battery cords are
connected.
BATTERY
Weak battery while in Bypass
mode. This usually indicates that the batteries
need replacing or the UPS requires service.
Contact your service representative.
SELF TEST
Self Test failure. UPS internal
problem. The UPS may switch to Bypass mode,
depending on the circumstances.
Reset the UPS by pressing the Output
|
On
button until the alarm beeps.
Contact your service representative if
condition persists.
Resetting the UPS
To reset the UPS while an alarm condition is present, press the
Output On button until the UPS alarm beeps.
Silencing the Alarm
To silence the alarm for an existing fault, press and hold the
Output On button for one second. The alarm becomes quiet.
If UPS status changes, the alarm beeps, overriding previous alarm
silencing. Press the Output On button again to silence the alarm.