Eaton Power Xpert 9395, Инструкция по установке и эксплуатации

Страница: 83 / 269

60 Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201725—Rev 15
Figure 30. ISBM Section to UPM Section Joining Brackets
Front View Base Bracket
UPM Section Base
ISBM Section Base
Bracket from Kit
Screw from Kit Screw from Kit
Top View Rear Bracket
UPM
Section Top
ISBM
Section Top
Screw from Kit Screw from Kit
Bracket from Kit
Back
Top View Front Bracket
UPM
Section Top
Screw from Kit Screw from Kit
ISBM
Section Top
Bracket from Kit
Front
44..44 EElleeccttrriiccaallllyy C Coonnnneeccttiinngg tthhee S Seeccttiioonnss
1. Unfasten the front door latch and swing the door open (see Figure 22 ).
2. Remove the door. Remove the retaining screw located inside the door at the bottom hinge pivot point,
then lift the door off. Retain the hardware for later use.
3. Remove the screws securing the ISBM section right bottom internal safety shield panel and remove the
panel to gain access to the internal input, output, and battery terminals. Retain the hardware for later use.
NOTE AC and DC input intercabinet power wiring harnesses are supplied coiled and secured in
the UPM wireway on the left side of the UPM section (see
Figure 29 )
4. Locate the AC and DC input intercabinet power wiring harnesses (long cables labeled xG1, xG2, and xG3).
Remove wire ties as necessary and uncoil the cables.
NOTE The 3G1 and 3G2 yellow, orange, and brown AC input intercabinet power wiring
harnesses are not supplied with the Power Xpert 9395-825/550 Two UPM UPS model.
5. Locate the 1G1, 1G2, 2G1, 2G2, 3G1, and 3G2 power wiring harnesses. Route these harnesses through
the wiring access in the right side panel of the ISBM section to the AC Input to UPMs terminals. See
Figure 31 for common rectifier feed with Continuous Static Switch (CSS) terminal locations.
UPS System Installation