Eaton PDI Revit Model
P-164001110—Rev 01
13
b.
While in the project, the clearance requirement is listed under
Properties
.
Dimensions
Front Clearance
3’ 0”
c.
Clearances can be turned on or off for display purposes only by toggling the corresponding box in the
Properties
tab. When a clearance box is unchecked, the clearance requirement is still in effect, but is
not displayed.
Other
PDI-Box-Front Clearance
44..22
S
Sttaarrtteerr R
Raaiill
Next add a Starter Rail to the bus run. The first bus rail connected to a Standard End Feed must be a Starter Rail
and cannot be a Standard Rail. There can be only one Starter Rail per bus run.
1.
Import the Starter Rail model.
a.
Align the middle axis of the Starter Rail with the middle axis of the Standard End Feed.
b.
To assure proper alignment, you should place a 0–inch dimensional constraint between the Standard
End Feed and the Starter Rail.
Figure 12. Standard End Feed and Starter Rail Dimensional Constraint
0’ - 0”
2.
The length of the Starter Rail can be adjusted in Revit to fit your needs, as follows:
a.
Highlight the Starter Rail.
b.
Select the
Properties
tab.
c.
Click on the Starter Rail drop down menu located at the top of the
Properties
tab.
