16
Eaton PDI Revit Model
P-164001110—Rev 01
3.
In the South elevation, dimensionally constrain the End Cap to make sure that it is in the same place as the
Stanard Rail by using the same dimensional constraint as for
, Step 4.
Figure 18. End Cap — Dimensional Constraint
0’
- 5 3/8”
0’
- 5 3/8”
44..55
H
Haannggeerrss ((V
Veerrttiiccaall))
For Hanging the bus run, attach the Hanger Brackets to rails.
1.
Make sure that the project is in
Floor Plans Level 1
view. (This makes it easier to place the Hanger on the
top faces of the rails.)
2.
Import the Hanger model.
3.
Click to place as many Hangers as needed on the top face of the rails.
Figure 19. Hanger Placement
4.
Align the Hangers from the ends of the rails by either sliding them into place, or by placing a dimensional
constraint.
