Eaton M-Max series, Руководство по эксплуатации

Страница: 194 / 199

Appendix
04/10 MN04020001Z-EN
190
System parameters
Hard- and Software Information
S1.1 833 - ro API SW ID - 128 0
S1.2 834 - ro API SW Version - 128 0
S1.3 835 - ro Power SW ID - 128 0
S1.4 836 - ro Power SW Version - 128 0
S1.5 837 - ro Application, ID - 128 0
S1.6 838 - ro Application, revision - 128 0
S1.7 839 - ro System load % 128 0
Communication
S2.1
1)
808 - ro Communication status In xx.yyy format
xx = Number of error messages
(0 - 64)
yyy = number of correct messages
(0 - 999) 128
S2.2
1)
809
/
rw Error bus protocol 0 = FB disabled
1 = Modbus RTU 128 0
S2.3
1)
810
/
rw Slave address 1 - 255 128 1
S2.4
1)
811
/
rw Baud rate 0 = 300
1 = 600
2 = 1200
3 = 2400
4 = 4800
5 = 9600
6 = 19200
7 = 38400
8 = 57600 128 5
1) These parameters are overwritten with the bus-specific parameters when a fieldbus connection (e.g. CANopen) is used. The parameter values
described in the manual of the fieldbus interface then apply.
S2.6 813
/
rw Parity type 0 = None, no
a
2 Stop bits
1 = Even, a 1 Stop bit
2 = Odd
a
1 Stop bit
129 0
S2.7 814
/
rw Communication timeout 0 = Not used
1 = 1 s
2 = 2 s
… 129 0
S2.8 815
/
rw Reset communication
status 0 = Not used
1 = resets parameter S2.1 129 0
Unit counter
S3.1 827 - ro MWh counter MWh 129 -
S3.2 828 - ro Operating days 0 - 0000 days 129 -
S3.3 829 - ro Operating hours 0 - 24 h 129 -
S3.4 840 - ro RUN counter, days 0 - 0000 days 129 -
S3.5 841 - ro RUN counter, hours 0 - 24 h 129 -
S3.6 842 - ro FLT counter Trip Counter: 0 - 0000 129 -
PNU ID Access right Designation Value range Page FS
(P1.3) User
setting
RUN ro/rw