Settings Options and Partitions Menus
Page 59
Press the Menu key to gain access to the setting menu to set another partition that
is not involved in the current setting event. Note that if the user is allocated to a
single partition, that partition may start setting immediately.
If a user defers a setting event, the control unit halts the warning timer, and defers setting
30 minutes from the start of the warning time. At that time, the control unit starts counting
down the warning timer again. The user can defer setting in this way a total of three times.
After the third deferral, the control unit sets the system
Note that deferring setting does not defer any unsetting events.
Setting Faults
If there is a fault that would normally prevent the system from setting, a calendar set event
will also fail. Before the time of a setting event, the control unit starts the calendar set
warning tone as usual, but at the setting time, the control unit will not set the system. The
c
ontrol unit will log the failure as “set fail”. At the same time, the control unit will activate
any output programmed as type Set Fail.
Note that if you assign zones the Force Set Omit attribute, the control unit will omit those
zones if they are active during a scheduled setting event.