Eaton EFX48 e-Fuse Series, Инструкция по установке и эксплуатации

Страница: 53 / 161

Preparation
Copyright © 2019 Eaton Corporation. All Rights Reserved.
IPN March 2019
53

Servicing and Maintenance
•
The RM3-340/440 contains hazardous voltages and hazardous energy levels. Before undertaking any
maintenance task refer to the Warnings on page 10.
•
If a maintenance task must be performed on a "live" system then take all necessary precautions to avoid
short-circuits or disconnection of the load equipment, and follow any "live-working" instructions
applicable to the site or the country of installation.
•
Only perform the maintenance tasks described in the Maintenance chapter. All other tasks are classified
as Servicing. Servicing must only be performed according to specific instructions and only by personnel
authorized by Eaton. This includes disassembly and/or servicing of any modules.
•
For further information on Servicing contact your local Eaton dc product supplier, or refer to the contact
details on page 161.

EMC Compliance
•
This Eaton product ("the equipment") has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the Federal Communications Commission (FCC) Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
•
The equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions in this installation guide, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a particular
installation.
•
If the equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
Changes or modifications to the equipment not approved by Eaton Corporation could void the FCC
authority to operate the equipment.
Inspecting the Equipment and Reporting Damage
Unpack the equipment and inspect it carefully for possible damage that may have occurred
while in transit. Do not use any damaged equipment.
Report any damage immediately, using a completed Equipment Incident Report on page 159.

Keep the original packaging to use if any item needs to be returned for replacement or
repair.