EASEPAL EC-380B, Руководство по техническому обслуживанию

Страница: 23 / 34

23
④
Find each end of the actuator is fixing on the U stay fork.
There are two plastic bush rings in the hole.
Attention: You must use the brace to support the footrest,
avoid the footrest drop suddenly while pulling out plastic bush rings.
⑤
Pull out plastic bush rings, then the zero gravity actuator
can be disassembled.
⑥
Proceed in the reverse order of disassembly when assembly.
18 Replacement of the main PCB
①
Turn off the power, then lay the back rest on the seat pad and pull out the terminals of the back rest.
②
Remove the screws(2pcs) securing the box of the main PCB on the iron tubes.
③
If you just remove the upper cover of main PCB box only, just need to operate the Zero-G 2 function to
raise the seat-rest, then remove the screws(9pcs) on the box to take down the up cover of the main
PCB box
④
Pull out all the terminals on the main PCB, disconnect the PCB supports, then the main PCB can be
removed.
⑤
Proceed in the reverse order of disassembly when assembly.
Comment: You can replace the part(s) that may be damaged on the board referring to the picture above,
which to remove the screws or connectors securing the damaged part(s).
Footrest actuator
Remove the screws(9pcs) on the
box to take down the up cover of
the main PCB box
Zero Gravity PCB
EMC
Transformer
Air pump
Main PCB Air valve