EAE EE-6435BWF, Инструкция по установке, эксплуатации и ремонту, Страница: 7 / 55

Installation, Operation and Parts Manual
EE-6435BWF
7
1.5 Potential risks and safety measures
1.5.1 RISK OF CRUSHING
Safety measures:
-During lift functioning, the operator must remain at the control station
-The presence of persons beneath the crossbeams and/or the platforms when they are moving, or the presence of persons inside the
danger zone indicated in the following figure is strictly prohibited.
-During operations persons are admitted to the area beneath the vehicle only when the vehicle is already in the elevated position, when
the crossbeams and platforms are stationary, and when the mechanical safety devices are engaged
-When the platforms (and vehicle) are lowering the operator must never be partly or completely underneath or near of the movable
structure.
-The lift operator must not start the lift until it has been clearly established that there are no persons in danger zone.
1.5.2
RISK OF IMPACT
Caused by the parts of the lift or the vehicle that are positioned at head height.
Safety measure:
Personnel must be careful to avoid impact with parts of the machine not marked with special colors.
1.5.3
RISK OF VEHICLE MOVING
Caused by operations involving the application of force sufficient to displace the vehicle.
In the case of large or particularly heavy vehicles, sudden movement could create an unacceptable overload or uneven load sharing.
Safety measure:
Make sure that the vehicle is properly stopped by the hand brake before being raised.
1.5.4
RISK OF VEHICLE FALLING FROM LIFT
This hazard may arise in the case of incorrect positioning of the vehicle on the platforms, incorrect stopping of the vehicle, or in the case of
vehicles of dimensions that are not compatible with the capacity of the lift.
Safety measure:
Check the vehicle after raising a short distance to ensure that it is correctly and safely positioned.
1.5.5
RISK OF SLACKENING OF LIFT CABLES
Caused by objects left leaning against the posts or on the platforms.
Safety measure:
Inspect the space above and below the load and the loading carrying devices. It shall be free of obstructions before operating.
1.5.6
RISK OF SLIPPING
Caused by lubricant contamination of the floor around the lift.
Safety measure:
The area beneath and surrounding the lift and also the platforms must be kept clean. Remove any oil spills immediately.
1.6 Noise level
Noise emitted during operating the lift should be less than 70dB (A). For your health consideration, it is suggested to place a noise
detector in your working area.