PROGRAMMING
3-8
Revised January 2001
Part No. 001-7780-501
Button
- Displays the following
screen that selects the channels in each Zone and
System that are in this scan list. Select each Zone
and then the channels to be included from that zone.
Delete Entry - Deletes the selected channel from the
scan list.
Scan Hold Time - This programs the delay that
occurs before radio-wide scanning resumes after a
message is no longer being received. Times of
0 - 7.5 seconds can be programmed (see Section
2.3.11).
Modify List Screen
Assign Function Buttons
Clicking “Assign Functions Buttons” in the left
pane or that button in the General screen displays the
following screen which programs the five front panel
option switches. These switches can be programmed
with a different set of functions for each operating
mode (conventional and SMARTNET/SmartZone).
Refer to Section 2.3.4 for more information.
Program the option switches as follows:
1. In the System Type pull-down menu, select the
mode to be programmed (either conventional or
SMARTNET/SmartZone).
Assign Function Buttons Screen
2. To program a switch, click the arrow to display the
pull-down menu and then select the desired function
from that menu.
3. Repeat for all switches and modes to be
programmed and then exit this screen by clicking
the Close button.
3.4.3 RADIO-WIDE CONVENTIONAL SCREEN
The radio-wide conventional screen is shown
above, and it is used to program the DTMF ANI ID.
This ID is used on channels programmed for pre- or
post-transmit ANI (see Section 3.5.4) and consists of
eight digits from 0-9.
3.4.4 RADIO-WIDE SMARTNET/SMARTZONE
SCREEN
The radio-wide SMARTNET/SmartZone screen
is shown on the next page, and it is used to program
the following parameters:
Full Spectrum CC Scan
In a SmartZone system, if all potential control
channel frequencies have been searched, the radio
enters a channel-by-channel search across the full
spectrum that the radio covers. The timer sets the time
