OPERATION
2-13
Revised January 2001
Part No. 001-9800-501
Direct Entry Method (With DTMF Microphone Only)
1. With a SMARTNET/SmartZone channel selected,
press and hold the Private Call option switch until a
tone sounds (approximately 1 second). The last ID
called is displayed on the upper line, and the private
call mode is indicated by “
C
” in the upper part of the
display.
2. Using the 0-9, #, and * keys, enter the 6-digit ID of
the mobile unit you are calling. To erase the last
digit entered, rotate the Select switch counterclock-
wise, and press the Private Call switch to cancel the
call.
3. Press the PTT switch to initiate the call. If the
entered ID is invalid, “INVALID” is momentarily
displayed and the call is not initiated. If the entered
ID is valid, the alias of the ID is displayed on the
lower line if it matches an ID in your call list. Other-
wise, only the ID you entered continues to be
displayed. Any of the following conditions may
then occur:
•
If the radio you are calling is on the air, telephone
type “ringing” is heard for 20 seconds or until the
called party answers.
•
If the called party answers and the call is
successful, the person’s voice is heard and the call
is carried on the same as a group call. To end the
call at any time, press the Private Call switch.
•
If the called party does not answer within 20
seconds, “NO ANSWR” is displayed and a contin-
uous tone sounds. End the call by pressing the
Private Call switch.
•
If the called radio is not in service, no ringing is
heard, “NO ACK” is displayed, and a continuous
tone sounds. End the call by pressing the Private
Call switch.
•
If neither your radio nor the radio being called is
authorized to make unit-to-unit calls, “NO ACK”
is displayed and a continuous tone sounds. End the
call by pressing the Private Call switch.
•
If the called party answers but the radio system is
busy, four low tones sound and “BUSY” is
displayed. When the system is no longer busy, the
called party automatically responds.
•
If an out-of-range condition exists or the radio
system is not in service, “NO SYS” is displayed
and a continuous tone sounds. End the call by
pressing the Private Call switch.
Receiving an Enhanced Private Conversation Call
This call is automatically received if a
SMARTNET/SmartZone channel is selected. Proceed
as follows:
1. When this call is received, a recurring unit call tone
(three beeps) sounds for up to 20 seconds and
“CALL RCV” is displayed on the lower line.
2. To answer the call, press the Private Call option
switch and then the PTT switch and begin talking.
The private call mode is indicated by “
C
” in the
upper part of the display, and the alias of the
incoming call is displayed if the ID is in your call
list. Otherwise, the unit ID is displayed.
NOTE: If
the Private Call option switch is not pressed before
the PTT switch, a group call is transmitted on the
selected group.
•
To end the call when the conversation is complete
or at any other time, press the Private Call switch.
•
If private calls are not permitted (Private Call
switch not programmed), press the Call Response
option switch, if available, to answer the call.
•
If the call is not answered within 20 seconds, it is
automatically terminated.
•
If the radio system is busy, four low tones sound
and “BUSY” is displayed. When the system is no
longer busy, the call back tone (four beeps) is
heard and your radio automatically starts transmit-
ting. Press the PTT switch to continue the call.
•
To ignore an incoming call, wait 20 seconds until
the recurring unit call tone stops sounding.
