E.F. Johnson Company 5300 ES Series, Руководство по эксплуатации

Страница: 49 / 142

March 2008 5300 ES Series Mobile Radio Operating Manual 4-11
Radio Wide Features
4.13.1.1 Determining Channels in Priority Scan List
Channels in the conventional priority scan lists are determined as follows. Channels in the
SMARTNET/SmartZone/P25 Trunked priority scan lists are indicated only when editing a
list (see “Editing a Priority Scan List”).
1 Enable Priority scanning as described in Section 4.12.1. Also select the scan list if
applicable as described in the following “Selecting a Priority Scan List” description.
2
Select the desired zone and then scroll through the channels by rotating the Select
switch. When the displayed channel is in the scan list (scanned normally), the
symbol is displayed next to the zone number as shown in the following illustration.
4.13.1.2 Selecting a Priority Scan List
Conventional Operation - The scan list is user selectable by the SCAN option switch.
Refer to Section 5.10.1 for more information.
SMARTNET/SmartZone/P25 Trunked Operation - The scan list can be temporarily
changed if the Scan (List) Select option switch is programmed or by pressing/holding the
scan button. Refer to Section 6.11.2 for more information.
Note Only Priority scan lists are selectable.
4.13.1.3 Editing a Priority Scan List
If the SCN ED (Scan Edit) option switch is programmed, priority scan lists can be user
edited as follows (all operating modes). Changes are permanent (cycling power does not
reselect a default condition). Proceed as follows:
1 Make sure that both priority and radio wide scanning are OFF (the rotating icon is
not indicated in the right status display). Select a conventional, SMARTNET/
SmartZone/P25 Trunked channel corresponding to the scan list being edited.
2 Select the scan list edit mode by pressing the
SCN ED
option switch. This mode is
indicated by a triangle in the upper left corner of the display (see Figure 2.3).
3
If applicable, select the list to be edited by rotating and then pressing the Select switch.
The selected scan list is indicated as “LIST x” as described in the preceding section. If
user programming is disabled on a list (conventional channels only), “NO EDIT” is
momentarily displayed and it cannot be edited.
Scan List Indicator
Channel
Number