Dynatron Dynatronics ibox, Руководство оператора

Страница: 15 / 35

15 Dynatron® ibox™ Operator’s Manual
|
Rev. 2
|
5/14/2019 Dynatron® ibox™ Operating Instructions
table of contents symbols & labels limited warranty prev
< >
next prev topic
< < >>
next topic
6.
Apply the “return electrode” to the area just proximal to the
“active electrode”
Make sure that the “return electrode” is not touching the “active
electrode” and that its position is in close proximity to the “active
electrode.”
7.
Attach the “return electrode” clip to the “return electrode”
The “return electrode” clip is dark gray in color. The clip may be
pressed onto the “return electrode” without having to grasp and
squeeze the clip. The clip should firmly grasp the electrode when
released.
8.
Attach the “active electrode” clip to the “active electrode”
The “active electrode” clip is light gray in color. The clip may be
pressed onto the “active electrode” without having to grasp and
squeeze the clip. The clip should firmly grasp the electrode when
released.
9.
Turn the device
On
Press the On/Off
key located at the
bottom-center
of the keypad
and hold the key
until the display
illuminates. The “Dynatron” logo will be
displayed followed by the software version
number as shown in the two illustrations.
The “Treatment Setup Screen” will then
be displayed allowing the user to choose
from a default, predefined treatment, or a
custom treatment.
Default Treatments
“Default Treatments” are commonly used treatment setups that have
been previously stored by the user from prior treatments or manufac-
turer’s settings. Default treatments allow for rapid treatment setups
without having to enter treatment polarities/modes and doses. These
treatments are stored inside the device’s microcontroller and are not
affected by removal of the batteries.
When the device is powered-on, default treatment parameters are
shown on the Treatment Setup Screen (see “Treatment Setup Screen”
graphic to the right below). In the example, the default treatment is
for a single phase, negative, 40 mA-min dose treatment. Dual phase
default treatments are displayed with the positive dose first and a “+”
sign followed by the negative dose and a “-” sign.
The default factory treatment parameters are a single phase, negative
polarity, 40 mA-min treatment.
To access and perform a default treatment
from the Treatment Setup Screen, the
user presses the up arrow key to start
the default treatment. The treatment will
commence at an intensity (current) of 0.5
mA. The display to the right will be seen
by the user.
The intensity of the treatment at this point is controlled by the up
and down arrow keys associated with the treatment channel. See
“Changing the treatment intensity” (#14) in this section of the manual
for further details.
Dynatron ibox logo
Default Treatment
Software Version
Treatment Setup Screen