Dynapac CS1400, Инструкция по эксплуатации

Страница: 17 / 118

Safety - when operating
4812162501_F.pdf 2018-04-25
Safety - when operating
Prevent persons from entering or remaining in
the danger area, i.e. a distance of at least 7 m
(23 ft) in all directions from operating machines. Prevent persons from entering or remaining in
the danger area, i.e. a distance of at least 7 m
(23 ft) in all directions from operating machines.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
The operator may allow a person to remain in
the risk zone, however he/she must be attentive
and operate the machine only when the person
is fully visible or has given a clear indication of
where he or she is.
Avoid driving across a slope. Drive straight up
and down sloping ground. Avoid driving across a slope. Drive straight up
and down sloping ground.
Driving near edges
Never operate with roller outside the edge, if the
substrate does not have full bearing strength or is
close to a slope. Never operate with roller outside the edge, if the
substrate does not have full bearing strength or is
close to a slope.
Keep in mind that the machine's center of gravity
moves outwards when steering. For example, the
center of gravity moves to the right when you steer
to the left. Keep in mind that the machine's center of gravity
moves outwards when steering. For example, the
center of gravity moves to the right when you steer
to the left.
Work driving
Avoid operating close to edges and ditches and the
like as well as on poor ground conditions that influence
the bearing strength and capacity to support the roller.
Pay attention to potential obstacles above the
machine, such as overhead cables and the branches
of trees etc.
Pay particular attention to the stability of the substrate
when compacting close to edges and holes. Do not
compact with a large overlap from the previous track in
order to maintain roller stability. Consider other
compaction methods such as remote-control or a
walk-behind roller close to steep slopes or where the
bearing strength of the substrate is unknown.
7