Dynapac CS1400, Инструкция по эксплуатации

Страница: 97 / 118

Maintenance measures - 500 h
4812162501_F.pdf 2018-04-25
Diesel engine - Oil change
Run the engine warm before draining the oil.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors. (Risk of
carbon monoxide poisoning). Make sure that ventilation (extraction) is
adequate if the engine is run indoors. (Risk of
carbon monoxide poisoning).
Switch off the engine and activate the parking
brake. Switch off the engine and activate the parking
brake.
Fig. Oil filter
1. Oil filter
2. Dipstick
3. Drain plug
1
3
2
Place a receptacle that is capable of holding at
least 19 liters (5 gallons) under the drain plug.
Hand in the drained oil and filter to an
environment-friendly waste disposal station. Place a receptacle that is capable of holding at
least 19 liters (5 gallons) under the drain plug.
Hand in the drained oil and filter to an
environment-friendly waste disposal station.
Observe care when draining hot engine oil. Wear
protective gloves and goggles. Observe care when draining hot engine oil. Wear
protective gloves and goggles.
Remove the drain plug (3). Allow all of the oil to drain
off and refit the plug.
Change the engine oil filter (1). See engine instruction
manual.
Fill with fresh engine oil; see Lubricant specification for
the correct grade of oil.
Check the dipstick (2) to ensure that the engine oil
level is correct; for details see the engine manual.
Hydraulic reservoir cap - Check
Fig. Hydraulic reservoir
1. Tank cap
1
Screw off the tank cap and check that it is not clogged.
Air must have unobstructed passage through the cap
in both directions.
If clogged in either direction, clean with a little diesel
oil and blow with compressed air until free passage is
assured or replace the cap with a new one.
Use protective goggles when working with
compressed air. Use protective goggles when working with
compressed air.
87