Dynapac CS1400, Инструкция по эксплуатации

Страница: 110 / 118

Maintenance - 2000h
4812162501_F.pdf 2018-04-25
Replacing the fuel filter / fuel prefilter
Fig. Engine compartment
1. Fuel filter
2. Fuel prefilter
2
1
Place a container underneath to collect fuel that runs
out when the filter is released.
Loosen and unscrew the fuel filter (1).
Replace the filter unit.
Unscrew the lower part of the fuel filter (2) and drain
off any water, and then replace the filter unit.
The filters are of the disposable type and cannot be
cleaned. Hand in to environment-friendly station.
The fuel should be taken to an
environment-friendly waste disposal station. The fuel should be taken to an
environment-friendly waste disposal station.
Refer to the engine manual for detailed
instructions when replacing the fuel filter. Refer to the engine manual for detailed
instructions when replacing the fuel filter.
Start the engine and check that the fuel filter is tight.
Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning. Ensure good ventilation (air extraction) if the
diesel engine is run indoors. Risk of carbon
monoxide poisoning.
NOTE! The new fuel filters must not under any
circumstances be pre-filled with fuel due to the purity
requirements of the fuel system.
Hydraulic reservoir cap - Check
Fig. Hydraulic reservoir
1. Tank cap
1
Screw off the tank cap and check that it is not clogged.
Air must have unobstructed passage through the cap
in both directions.
If clogged in either direction, clean with a little diesel
oil and blow with compressed air until free passage is
assured or replace the cap with a new one.
Use protective goggles when working with
compressed air. Use protective goggles when working with
compressed air.
100