Dynapac CS1400, Инструкция по эксплуатации

Страница: 85 / 118

Maintenance, 10h
4812162501_F.pdf 2018-04-25
Fig. Water system (basic setting)
1. Water pump
2. Water filter housing
1
1
2
2
Inspect the intake water filters of the pumps every day.
The water filter housing (2) can be removed.
Flush the housing and the filter clean with water and
then put them back into place.
Only use clean water in the water tank. Only use clean water in the water tank.
The water system must be completely drained
if the roller is to be left unused for a longer
period or if temperatures below zero can be
expected. Remove the bottom plug to drain the
tank. The water system must be completely drained
if the roller is to be left unused for a longer
period or if temperatures below zero can be
expected. Remove the bottom plug to drain the
tank.
There are two filters located behind the fuel tank.
Brakes - Check
Fig. Instrument panel
2. Forward/reverse lever
12. Parking brake knob
29. Control lamp, brake
2
12
29
Check operation of the brakes as follows: Check operation of the brakes as follows:
Drive the roller slowly forward.
Activate the parking brake (12).
The brake warning lamp (29) should light up and the
roller should stop.
After checking the brakes, put the forward/reverse
lever (2) in neutral before resetting the parking brake.
Set the parking brake knob to the left.
75