DynaGen TG410, Руководство пользователя

Страница: 31 / 67

Settings
30
© 2017 DynaGen Technologies Inc TOUGH Series Manual
Name Active Mode Description
Warmup Warmup Timer Active after Warmup timer has expired to apply load to engine.
Cooldown Cooldown Timer Active when Cooldown timer is active.
Engine Running Running Active after crank success.
Exercising Exercise Timer Active during the engine exercising cycle.
Batt. Recharge (Battery
Recharge) Battery Recharge
Timer Active during the battery recharge cycle.
Maintenance
(Maintenance Required) Global Active when Maintenance timer has expired. If the timer has expired when the
controller is in the RUN mode the output does not turn on until the controller
enters the OFF or AUTO mode. See the
Maintenance section.
LowBat InCrank (Low
Battery During Cranking) Cranking Active when Low Battery During Cranking warning is displayed.
Aux Sensor 1
Auxiliary Settings
Dependent
Active dependent upon settings in the Auxiliary sensor section.
Aux Sensor 2
Aux Sensor 3
Aux Sensor 4
Force Regen User Controlled When user triggers a Force Regeneration, output is active for 20 seconds
then switches off.
Regen Inhibit User Controlled When user triggers a Regeneration Inhibit, output is active for 20 seconds
then switches off.
Common Failure Any Failure Active when any failure occurs.
RPM Increment Running Output is used to to trigger inputs on an ECM to control speed. See Front
Panel Speed Control section for more information.
RPM Decrement Running Output is used to to trigger inputs on an ECM to control speed. See Front
Panel Speed Control section for more information.
DEF Fluid Pump Running Active when DEF Fluid Level falls below the DEF Low Level and stays active
until the level rises above the DEF High Level. See
CAN Bus (J1939) section
for more information.
Genset Disable Global Disables the generator during a stationary Regen on Kubota engines (see
Aftertreatment in the J1939 User Manual ) or also during an engine IDLE
condition from the IDLE switched input. Automatic idle is ignored. If the
generator voltage is not below the under voltage setpoint in 10s, the controller
will shut down the engine on "Generator Disable Failure."
Dummy Load Running Output is controlled by the dummy load feature.
Breaker Trip Running Output is controlled by the Over Current Failure or IDMT features and by the
Load Imbalance feature.
Auto Idle Warm-up, Cooldown Active when the warm-up or cooldown idle is active. See Warm-up Idle and
Cooldown Idle in
Engine Logic . This does to react to the Idle switched input.
Warning Functions
Functions
Low Engine Temperature High Engine Temperature Low Oil Pressure Under Speed
Over Speed Low Fuel Level High Fuel Level Low Battery Voltage
High Battery Voltage Under Frequency Over Frequency AC Under Voltage
AC Over Voltage Over Current Fuel In Basin Battery Charger Fault
Configurable Warning 1 Configurable Warning 2 Auxiliary Sensor 1 Auxiliary Sensor 2
Auxiliary Sensor 3 Auxiliary Sensor 4