DynaGen TG410, Руководство пользователя

Страница: 25 / 67

Using the Controller
24
© 2017 DynaGen Technologies Inc TOUGH Series Manual
3.2
Using Cooldown Mode
When the controller is configured to have a cooldown period (See Engine Logic section) for the engine, there is some special
functionality that must be considered.
The cooldown period is special in that during this time, it will accept a Start Command. This means if the engine is cooling down
and a start command is received, the controller will be placed back into a running mode and will not shut down.
Example: The following is an example of how the cooldown functionality works.
1. Remote Start contacts close
2. Engine starts and is in the running mode
3. Remote Start contacts open
4. Engine starts cooldown period
5. User presses RUN button on the front panel
6. Engine moves back into running mode and does not shut down
7. Engine can now only be shut down by using the OFF button or Emergency Stop input
3.3
Warnings
Warnings are conditions that alert the user to possible issues. These get enabled/disabled when you enable/disable various
settings in the controller.
Notable warnings are given in the below table.
Warning
Name Enabled Condition(s) Description
High Fuel
Level High Fuel Level not disabled (in Sensors > Fuel
Level menu). High Fuel Level warning. This is often used to indicate an over
fueling condition where fuel could be overflowing from the fuel
tank.
Low
Engine
Temp Low Engine Temp not disabled (in Sensors >
Engine Temp. menu). Low Engine Temperature warning. This is often used to indicate a
malfunction of the engine block heater in stationary generator
applications.
Low Oil
Pressure Switched input set to "Oil Pres. Warn" function.
See
Switched Inputs . Triggered if switched input is
active during the RUN mode.
Low oil pressure warning.