Figure 4-18 Removing the LCD Assembly
Installing the LCD Assembly
Install the LCD assembly according to the following procedures:
1.
Place the logic upper assembly upside down so that the bottom is facing up.
2.
Rotate the LCD hinges to a 180-degree angle and seat the LCD assembly in the correct position on
the logic upper assembly, and the cables must be placed inside the hook of hinge bracket
□
,4
3.
Tighten the four M2.5×5 screws to secure the LCD assembly to the logic upper assembly as shown
in Figure 4-18.
□
,3
4.
Route and secure the W-LAN cables and edp cable in the routing channels on the logic upper
assembly as shown in Figure 4-17.
□
,2
□
,1
NOTE:
Take care not to pinch the antenna cables. Make sure the routing positions of the
antennas are correct and do not block any components, such as screw holes.
