12
RMO60TD Getting Started
Setting the Measurement Parameters
Directly after the first display RMO60TD automatically changes to the
Current
menu and the
green LED lights up.
Before a test can be started, the following needs to be defined in the
Current
menu:
Test current; the following values can be chosen:
5 mA, 10 mA, 50 mA, 100 mA, 500 mA, 1 A, 2 A, 5 A, 10 A, 15 A, 25 A,
30 A, 40 A, 50 A and
60 A.
Memory position, 000-499
Test duration time.
In the
Current
menu, define a test current for the test (here
500 mA
). To do so, set the value of your
choice by means of the
UP/DOWN
buttons. Define the test duration time and then the memory position
(here
MEMORY:123
).
Using
RIGHT
move the cursor to the memory location position, and using
UP/DOWN
select the desired
memory position to which obtained results would be saved. Once the test is completed (either due to
time expiration or when pushing
STOP
) the last measured result will remain registered in RMO60TD, and
the memory position is automatically switched over to the next memory position. The result can be
recalled later by selecting that position number.
Using
RIGHT
button move the cursor to the test duration position, and using
UP/DOWN
select desired
value.
Measuring with RMO60TD
Before a test can be started, test current, memory position and the test duration time need to be defined
using the
Current
menu.
Once these parameters are defined, press
ENTER
to change to the
Ready
state.
The
Ready
state displays the selected test current and its duration is defined. If one of these values has
to be changed, press
STOP
to return to the
Current
menu.
The flashing green LED indicates that RMO60TD is now ready to start the test. Press
START
to run
a test. At the start of the test, a cable connection check is done. In case of e.g. a disconnection, an
alarm is activated and the error message is shown on the display.
During the test, both the green and the red LEDs flash alternately. When the current is stabilized,
RMO60TD starts the measurement of the test object resistance.
Figure 6-4:
The
Current
menu
Test current Memory position
Test duration time
Menu name
Figure 6-5:
The
Ready
state
before the test
Memory
Time and Date
