DURKOPP ADLER 577 Series, Руководство пользователя

Страница: 196 / 202

11.3 Parameter list of the technician level ( accessible via the technician code "1907" )
Change over to the technician level
–
Turn off main switch.
–
Hold the key "P" on the control panel pressed down and turn on
the main switch.
–
Release the key "P" and enter the code number "1907" .
( See the Operating Instructions of the motor manufacturer. )
–
Press key "E" .
The control will change over to the technician level,
The parameter
"F - 100" will be displayed.
Parameter Denomination Setting
max min Standard
F - 100
F - 111n2
F - 115n6
F - 170Sr1
F - 173Sr4
F - 179
F - 195
Softstart-Stitch number
Upper limit of the setting sector of the maximum speed
Softstart-speed
Setting the reference position
Position 0:
Thread take up lever short before the upper dead point,
Introduce the pin into the groove of the arm shaft!
Checking the signal outputs and inputs by the
Variocontrol V810
01 = Sewing basket down ( ST2/34 )
02 = Sewing basket up ( ST2/35 )
03 = Knife ( ST2/37 )
04 = Sewing cycle ( ST2/27 )
05 = Needle cooling ( ST2/28 )
06 = Machine runs ( ST2/26, B4/6 )
07 = LED remnant thread monitor on the right ( ST2/25 )
08 = LED remnant thread monitor on the left ( ST2/23 )
By operating the switches connected to the control their
function will be checked and the display will present
"on
/ oFF" .
Displaying the programme number of the control unit
with index and ID number.
The date will be presented in succession by pressing the
key
Key B .
Hook thread monitor
0 = Hook thread monitor Off
1 = Optical hook thread monitor;
Sewing basket down after counting
2 = Optical hook thread monitor;
Sewing basket up after counting
3 = Function like Setting 1
4 = Monitoring the hook thread by counting the
buttonholes
( Number of buttonholes according to the
setting of the parameter
"F - 085"
254
5000
2500
0
n2_
70
0
1
4000
1300
46