❏
6. Remove the receiver battery holder from the radio box.
Install (4) “AA” (included) into the battery holder in the
configuration molded into the battery holder.
❏
7. Re-install the receiver battery holder under the radio
plate. Make sure that the receiver switch is in the off position.
Plug the connector on the receiver battery into the socket on
the receiver switch. Tuck the wires between the servo and
receiver battery so they will not get caught on anything.
❏
8. Install the transmitter antenna by screwing it into the
hole on the top of the transmitter.
❏
9. Slide open the battery door on the bottom of the
transmitter. Place 8 “AA” batteries into the holder in the
configuration molded into the plastic on the battery holder.
Re-install the battery door.
❏
10. Turn on the transmitter using the switch on the side
(see photo step 9). The red light on the side of the
transmitter should light up. If there is no light on, turn the
transmitter off and check to ensure that the batteries are
making contact with the metal contacts in the battery holder.
Make sure the batteries are installed correctly. Turn the
transmitter on and check for the red light. If the red light
appears, turn off the transmitter. If the red light blinks, the
batteries are low and should be replaced.
❏
11. Remove the plastic from the outside of the body.
Apply the decals if desired. For decal placement, see the
photos on the box top.
❏
12. Assemble the rollbar as shown using eight 2.6 x 6mm
self-tapping screws.
5
