❏
5. Insert the throttle rod into the outer hole in the
carburetor arm. Assemble in order, a 2mm collar and the
throttle spring. Next insert the throttle rod through the rod
connector on the throttle servo.
❏
6. Install a 2mm collar at the end of the brake rod and
another 2mm collar at the end of the throttle rod. Place a
small amount of thread locking compound on two of the (3)
3 x 3mm set screws and thread them into the 2mm collars.
Do not tighten the set screws all the way. In the next section
we will make adjustments to the collars.
• Turn on the transmitter first, then the receiver.
• Center the trims of the throttle and steering channels (see your
radio system manual for the location of the trim adjustments).
Steering Linkage Set Up
A) Remove the servo horn from the steering servo.
B) Position the front wheels so they are aimed “straight
ahead” (note that the tires are aligned slightly inward – this
is called toe-in).
C) Re-install the arm facing straight up (see photo above).
Throttle Linkage Set Up
A) With the radio system still on, set the throttle in the
neutral position.
B) Remove the servo arm from the throttle servo and
replace the arm so that it is aligned with the centerline of the
throttle servo case as shown in the picture above.
C) The brake lever should be perpendicular to the centerline
of the chassis as shown above.
D) Tighten the 2mm collar on the brake rod so that it is 3/32"
(2mm) away from the brake lever.
RADIO ADJUSTMENTS
12
