❏
2. Use the (4) 3 x 8mm self-tapping screws to attach the
throttle servo to the throttle servo mounts.
❏
3. Use the (4) 3 x 8mm self-tapping screws to attach the
throttle servo and the mounts to the chassis. Make sure that
the servo spline is towards the rear.
❏
1. From bags PA001 and PA003, remove the brake rod,
the throttle rod, the brake spring, (3) 3 x 3mm set screws,
the 2mm nut, the rod connector, and (3) 2mm collars.
❏
2. From your radio system remove a large, X-shaped
servo arm. Remove two of the servo arms as shown. Install
the rod connector in the last hole on the arm as shown in the
diagram above (approximately 3/4" or 18mm). You will need
to enlarge the hole with a hobby knife or a 5/64" (2mm) drill
to fit the rod connector. Apply a small amount of thread
locking compound (not included), on the nut to hold it in
place. Secure the rod connector to the servo arm with the
2mm nut. Do not tighten the nut completely. The rod
connector should swivel easily.
❏
3. Insert the brake rod as shown in the photo. Insert the
brake rod into the servo arm from the bottom, into the
second hole from the outside of the arm (approximately 5/8"
or 16mm from the center).
❏
4. Place the servo arm on the throttle servo as shown in
the photo above and place the brake rod through the brake
lever. Do not install the servo arm screw yet. You will need
to make adjustments before running your truck.
Rod Connector
5/8"
(16mm)
THROTTLE AND BRAKE LINKAGES
11
