❏
1. Remove the transmitter and truck from the box.
❏
2. Remove the twist-tie from the receiver antenna. (The
receiver antenna is a bundled thin wire that is attached to the
receiver.) Thread the receiver antenna underneath and
through the hole in the radio plate next to the receiver switch.
❏
3. Remove the antenna tube from the parts bag. Thread
the receiver antenna through the antenna tube. The antenna
will be longer than the antenna tube.
DO NOT COIL OR CUT
THE ANTENNA.
Press fit the antenna tube through the hole
in the radio plate. Place a 1/8" long piece of fuel tubing over
the antenna tube and wire to secure in place.
TIP:
Run the
antenna through your fingers to straighten out kinks before
running through the antenna tube.
❏
4. Thoroughly soak the air filter foam with some oil (not
included) and then squeeze out the excess oil. DuraTrax Air
Filter Oil (DTXC2465) is available from your local hobby dealer.
Attach the adapter tube to the air filter base with one of the
included tie straps. Place the air filter onto the carburetor and
secure it in place with the other included tie strap. Cut off the
excess part off of both straps.
❏
5. Remove the four screws from the top of the radio plate
and remove the receiver battery holder.
4
FINISHING THE MAXIMUM MT PRO RTR VERSION (DTXD91**)
