Dulas Solar VC150, Руководство пользователя

Страница: 10 / 156

10
SOLAR ARRAY
KYOCERA MODULE ASSEMBLY
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE COMMENCING
(FOR 12V WIRING LAYOUTS SEE ‘JUNCTION BOX WIRING DIAGRAMS’)
After insuring that all the components are present, remove the
solar (module a.1) from their cardboard boxes and lay them next
to each other on top of the cardboard, with glass facing down.
Do not step on the glass module. BROKEN MODULE CANNOT
BE USED. Arrange the solar modules so that the junction boxes
are all on the same side.
Interconnected the modules with the cables provided (a.3). The
interconnected cable has a crimped ring terminal at each end
which are easily connected to the Kyocera junction boxes as
illustrated below in figure1, (remove plastic unit, screw gland in
place, replace plastic nut and connect cable.)
The array output cable (a.2) must then be connected to the
nearest module (see system wiring diagram), brown or red wire
to +, blue or black wire to -. Ensure that there is sufficient cable
to meet the necessary distance then insert into the junction
boxes as performed previously.
Note: Due to New cable color regulations brown or red can be
used for + ve and blue or black for – ve until 1/4/06 after which
time only brown and blue will be permissible.
Lift the cover of the junction box by removing the four screws.
Place the ring terminal into position and tighten up the terminal
screw until it is gripped securely. Replace the cover of the
junction box with the screw provided ensuring a moisture proof
seal.