Dulas Solar VC150, Руководство пользователя

Страница: 83 / 156

83
5 Disconnect at the compressor controller the wires from the thermostat and fan (if
fitted). Fit a temporary wire between terminals T and C of the compressor controller.
6.Replace the fuse with a good fuse of the correct type and switch on the
refrigerator.
7. If the refrigerator runs there is fault in the thermostat or fan, which is causing the
fuse to blow, when they are connected. Connect each one separately to determine
which is faulty-the thermostat or the fan.
8. If the fuse blows again, switch OFF the refrigerator, remove the electrical socket
from the compressor. (This disconnects the compressor controller from the
compressor), fit a new fuse, and switch on the refrigerator.
9.If the fuse does not blows with the compressor socket disconnected, the fault is
probably in the compressor. Proceed with the next steps in the faultfinding Chart to
make sure of your diagnosis before replacing the compressor.
10. If the fuse blows each time you replace it and switch on the fridge with and
without the compressor socket disconnected, then change the compressor controller
(see page 85)
11. Fit a new fuse and switch ON the refrigerator again. If with the new compressor
controller the fuse does not blow the fault was the compressor controller. If the fuse
continues to blow, PROCEED TO THE NEXT STEP ON FAULT FINDING CHART
no.1
DO NOT FORGET TO REPLACE THE FUSE LATER WHEN THE FAULT IS
FOUND.