![background image](http://html1.mh-extra.com/html/ducati/slide-1043-24v/slide-1043-24v_installation-instructions-manual_2537587028.webp)
28
DUCATI
K E Y S E L E C T O R
KEY 5000
92 mm
54 mm
25 mm
It is used to command the opening or closing of the gate.
The key selector must be connected to the "START" or "PEDESTRIAN START" contact of the motorization electronic
board. Use a 0.5 mmq bipolar cable. No polarity to respect.
Installation:
1- Unscrew the fixing screw.
2- Choose the desired position and identify the points to drill.
3- Fix to the wall using screws and plugs (not supplied), remembering to pass the power cable (not supplied, 0.5mm²
recommended) through the cable passage and reposition the sealing gasket.
4- After connection (see connections section) replace the cover on the key switch and screw the plug.
Electrical connection
1 – Connect the two wires of the power cable to the screw terminals. (Diagram 4).
2 – Close the box (diagram 2).
3 – Pull the cable from the key switch to the electronic board of your engine.
4 – Connect the cable to the relative terminal blocks specified in the general wiring diagram in the manual of the auto-
matic door. (see contact "HOME" or "PEDESTRIAN HOUSE").
Note: polarity does not matter.
Joint
d’étanchéité
(à placer entre
le mur et le capot)
Passage
de câble
Schéma 1
Mur
Schéma 3
Fixing
Fixing
hole
hole
hole for
hole for
cabling
cabling
gasket
gasket
Fixing
Fixing
hole
hole
wall
wall
Fixing
Fixing
hole
hole
switch
switch
to the "START"
to the "START"
contact on the main
contact on the main
electronic board
electronic board
Cable
Cable