DSE Model 7560 ATS and Mains Controller Operators Manual
057-017 7560 OPERATING MANUAL ISSUE 10.2 10/02/09 AM 47
7.5 THE FRONT PANEL CONFIGURATION EDITOR
This configuration mode allows the operator limited customising of the way the module operates.
7.5.1 ACCESSING THE FRONT PANEL CONFIGURATION EDITOR.
•
Press the Stop/Reset
and Info
buttons simultaneously.
•
If a module security PIN has been set, the PIN number request is then shown :
•
Press
(up) or
(down) to adjust it to the correct value.
•
Press
(right) when the first digit is correctly entered. The digit you have just entered will now
show ‘#’ for security.
•
Repeat this process for the other digits of the PIN number. You can press
(left) if you need to
move back to adjust one of the previous digits.
•
When
is pressed after editing the final PIN digit, the PIN is checked for validity. If the number is not
correct, you must re-enter the PIN.
•
If the PIN has been successfully entered (or the module PIN has not been
enabled), the editor is displayed :
EDITING A PARAMETER
•
Enter the editor as described above.
•
Press the left or right buttons to cycle to the section you wish to view/change.
•
To edit the parameter, press
to enter edit mode. The parameter begins to flash to indicate that you
are editing the value.
•
Press the up
or down
buttons to change the parameter to the required value.
•
Press
to save the value. The parameter ceases flashing to indicate that it has been saved.
•
To exit the editor at any time, press the
button.
NOTE: When the editor is visible, it is automatically exited after 5 minutes of inactivity to ensure security.
NOTE: The PIN number is automatically reset when the editor is exited (manually or automatically) to
ensure security.
NOTE: More comprehensive module configuration is possible using the 75xx series PC configuration
software. Please contact us for further details
NOTE: The contents of the tables overleaf may differ depending on the actual module configuration.
