DSE Model 7560 ATS and Mains Controller Operators Manual
057-017 7560 OPERATING MANUAL ISSUE 10.2 10/02/09 AM 27
5 OPERATION
5.1 CONTROL
Control of the DSE7560 MK1 module is via push buttons mounted on the front of the module with
STOP/RESET, MANUAL, TEST, AUTO, ALARM MUTE and START functions. For normal
operation, these are the only controls which need to be operated. The smaller push buttons are
used to access further information such as mains voltage or to change the state of the load
switching devices when in manual mode. Details of their operation are provided later in this
document.
The following descriptions detail the sequences followed by a module containing the standard
‘factory configuration’. Always refer to your configuration source for the exact sequences and timers
observed by any particular module in the field.
CAUTION: - The module may instruct an engine start event due to external influences.
Therefore, it is possible for the engine to start at any time without warning. Prior to
performing any maintenance on the system, it is recommended that steps are taken to
remove the battery and isolate supplies.