DSE 8610 MKII, Руководство оператора, Страница: 164 / 188

Front Panel Configuration
057-254 ISSUE: 2 Page 164 of 188
7.1 MAIN CONFIGURATION EDTIOR
7.1.1 ACESSING THE MAIN CONFIGURATION EDTIOR
NOTE: More comprehensive module configuration is possible via PC configuration
software. For further details of module configuration, refer to DSE Publication: 057- 238
DSE8610 MKII Configuration Suite PC Software Manual.
•
Ensure the engine is at rest and the module by pressing the Stop/Reset Mode button.
•
Press the Stop/Reset Mode and Tick buttons together to enter the main configuration
editor.
7.1.2 ENTERING PIN
NOTE: The PIN is not set by DSE when the module leaves the factory. If the module has a
PIN code set, the generator supplier has entered this. Contact the generator supplier if the
code is required. If the code has been ‘lost’ or ‘forgotten’, the module must be returned to the
DSE factory to have the PIN removed. A charge is made for this procedure. This procedure
cannot be performed away from the DSE factory.
NOTE: The PIN is automatically reset when the editor is exited (manually or automatically)
to ensure security.
•
If a module security PIN has been set, the PIN request is then shown.
•
Press the Tick button, the first ‘#’ changes to ‘0’. Press the Up or Down buttons to
adjust it to the correct value.
•
Press the Right button when the first digit is correctly entered. The digit previously entered
now shows as ‘#’ for security.
•
Repeat this process for the other digits of the PIN number. Press the Left button to move
back to adjust one of the previous digits.
•
When the Tick button is pressed after editing the final PIN digit, the PIN is checked for
validity. If the number is not correct, the PIN must be re-entered.
•
If the PIN has been successfully entered (or the module PIN has not been enabled), the editor is
displayed.