15
4 C: Entering the Placement Test Mode
Test the placement of the First Sounder before testing other components!
Carry the Keypad to the location of the component to be tested. The location
of the Keypad will not affect the test, as the Placement Test Mode tests the
component’s ability to communicate with the Controller and Sounder, not the
Keypad.
P
L
A
C
EM
EN
T
AN
D
TE
S
T
ING
Enter the Installer’s Programming Mode as described in 5 A: How to Enter
the Installer’s Programming Mode.
Use the
-NO Key to scroll to this message.
When this message is displayed, press the
-YES Key.
Enter Programming Section [81].
With this message displayed, press the
-YES Key.
Use the
-NO Key to scroll to the first
component to be tested.
Press the
-YES Key to test the displayed
component.
Hold the component as close to its intended location as possible.
*
The "ZONE LABEL" can be any discription of up to 16 letters, numbers, spaces or ASCII
characters. See Section 6 for more information.
Test each component on the system as described here:
Keypad
Press the [#] Key to test the Keypad; the Keypad will display the test result.
Do not remove the Keypad Backplate from the Keypad
during the Placement Test.
Sounder
Remove the Sounder from its backplate, wait 5 seconds, then reattach the
Sounder to its backplate. The Keypad will display the test result after the
Sounder is reattached to its backplate.
Door Contact
Open and close the contact by moving the magnet or operating the
external device connected to the Door Contact. The Keypad will display
the test result after the zone is restored.
Motion Detectors
Remove the Detector from its backplate, wait 5 seconds, then
and Smoke Detectors
reattach the Detector to its backplate. The Keypad will display the test
result after the Detector is reattached to its backplate.