13
3 G: Removing Components from the System
Follow the procedure below to remove components from the system. You may wish to remove
components for the following reasons:
• The component is no longer required on the system
• A mistake was made in enrolling the component
• The component is not working and requires service
Enter the Enrollment Mode as described in
3 B: Entering the Enrollment Mode
A
DDI
NG
CO
M
P
O
N
E
N
T
S
When this message is displayed, press the
-YES Key.
Use the
-NO Key to scroll to this message.
When this message is displayed, press the
-YES Key.
Use the
-NO Key to scroll through the list
of components. A message similar to this
will be displayed for each component.
When the desired component is displayed,
press the
-YES Key to remove the
component. The Sounders will sound a
single short beep and this message will be
displayed.
After a component is removed, this message
will be displayed. Press the
-YES Key to
remove another component, or press the
-NO Key.
To display the Serial Number of a
component, press the [
∗
] Key while viewing
the list of components. When the [
∗
] Key is
pressed, a message similar to the one shown
here will be displayed.