7
Chapter Three: Adding Components explains how to:
• Add the first Keypad to the system
• Enter the Enrollment Mode
• Add components to the system
• Review the list of components on the system
• Remove components from the system
Chapter 3: Adding Components
A
DDI
NG
CO
M
P
O
N
E
N
T
S
3 A: Enrolling the First Keypad
Two sets of batteries are provided with the keypad. When programming the system, because
of the length of time required, as well as the amount of communication that occurs between the
keypad and controller, the life of the batteries may be reduced. This may cause a low battery
condition to occur before the expected 20 to 24 month battery life period. After programming
the system completely, replace the batteries in the keypad with the second set, to ensure they
are fresh and fully charged.
Install four of the eight supplied AA batteries in the Keypad. Refer to the label
on the back of the Keypad and ensure that the batteries are installed correctly.
When you are done installing and programming the WLS900 system, replace the four batteries in
the keypad with the second supplied set.
Press the [#] Key; this message will be
displayed.
Press the [#] Key; this message will be
displayed.
The Controller Serial Number is printed on
the back of the Controller. Enter the Controller
Serial Number.
Press the
-YES Key. When the Keypad is
successfully enrolled, it will return to its
inactive state.
Secure the Keypad to its Backplate.
This message will be displayed if the Keypad
is unable to enroll with the Controller. If the
Keypad does not enroll with the Controller,
check the following:
• Ensure that the Controller’s AC Adaptor is properly connected to the
Controller and is plugged in
• Ensure that the Keypad’s batteries are new and properly installed
• Ensure that the Controller serial number was entered correctly
• The Keypad and Controller may be out of range; try enrolling the Keypad
with the Keypad and Controller in the same room.
• Reset the Keypad and the Controller by following the instructions on
performing a hardware reset on page 43.