[702] Second International Option Codes
43
[702] Second International Option Codes
1
ON Pulse Dialing Make/Break Ratio 33/67
☞
European Pulse Dial Standard
OFF Pulse Dialing Make/Break Ratio 40/60
✓
☞
North American Pulse Dial Standard
2
ON Force Dialing Enabled
✓
If the first attempt by the system to call the monitoring
station fails, on subsequent attempts, the system will dial
the number regardless of whether there is a dialtone
present or not.
☞
The system will go ‘off-hook’, search for a dialtone
for twenty seconds, hang-up for five seconds, go
‘off-hook’, search for a dialtone for five seconds,
then dial (this applies if no dialtone is present)
.
OFF Force Dialing Disabled
The system will not dial the programmed telephone num-
ber if a dialtone is not present.
3
ON Land line Test Transmission is in Minutes
The value programmed in
section [370] option 7
is in
minutes.
OFF Land line Test Transmission is in Days
✓
The value programmed in
section [370] option 7
is in
days.
4
ON 1600 Hz Handshake
The communicator responds to a 1600Hz handshake for
bps formats.
OFF Standard Handshake
✓
The communicator responds to the handshake desig-
nated by the format selected in
section [360].
5
ON I.D. Tone Enabled
After the telephone number is dialed, the system emits
the tone programmed in option 6.
OFF I.D. Tone Disabled
✓
6
ON I.D. Tone Frequency = 2100 Hz
This tone is enabled in option 5.
OFF I.D. Tone Frequency = 1300 Hz
✓
This tone is enabled in option 5.
7
ON 1-Time/1-Hour DLS Window enabled
Allows the user to initiate a DLS downloading session.
OFF 6-Hour DLS Window enabled
✓
8
ON Bell on FTC when Armed
If a failure to communicate trouble is generated while the
system is armed, the bell output will sound for the time
programmed in
section [005]
or until the system is dis-
armed.
OFF FTC Trouble only when Armed.
✓
If a failure to communicate trouble is generated while the
system is armed, the bell output will not sound but the
keypad buzzer will sound trouble beeps until a key is
pressed.
[703] Delay between Dialing Attempts
For standard (force) dialing the system will search for a dialtone
for 5 seconds, hang up for 20 seconds, search for a dial tone for
5 seconds then dial. If there is no initial handshake recognized
within 40 seconds, the system will hang up. This timer adds a
delay before the next call is attempted. The default is one sec-
ond (001) delay for a total of six seconds.
Default
001
I___I___I___I
000 - 255 second
firealarmresources.com
Содержание Envoy NT9005EU
Страница 58: ...NOTES firealarmresources com ...