Dru Metro 130XTL RCH, Руководство по установке

Страница: 4 / 40

Eng
lish
INSTALLATION MANUAL
3. SAFETY
3.1 General
!Caution
• Observe the generally applicable regulations and precautions/safety instructions in this manual.
• First check – in appendix 2, table 2 – whether the appliance to be installed has the correct technical version.
• Read the manual carefully to ensure a proper and safe installation of the appliance.
• Observe the regulations/instructions in this manual.
3.2 Regulations
Please install the appliance in accordance with the applicable national, local and constructional (installation)
regulations.
3.3 Precautions / safety instructions at installation
Carefully observe the following precautions/safety regulations:
Ø
The appliance may only be installed and maintained by recognised installers who are skilled in the field of gas
heating and electricity.
Ø
Do not make any changes to the appliance.
Ø
When installing a built-in appliance:
•
Use non combustible and heat-resistant materials for the chimney breast, including the top of the chimney
breast, the material in the chimney breast and the back wall against which the appliance will be placed.
For this you can use both sheet material and stone-like materials.
• Take sufficient measures to prevent temperature of a wall behind the chimney breast becoming too high,
including the materials and/or objects behind the wall.
• Comply with the minimum required internal sizes of the chimney breast.
• Vent the chimney breast by means of ventilation holes with a combined passage as stated further down in
the text.
• Use heat-resistant electrical wiring.
• Place heat-resistant electrical wiring away from the appliance and as low as possible in the chimney breast.
This has to do with the temperature development in the chimney breast.
Ø
Only use the flue gas discharge / combustion air supply system supplied by DRU.
Ø
When installing a free-standing appliance: place the appliance away from the back wall by the minimum distance
stated further down in the text.
Ø
Do not cover the appliance and/or do not wrap it in an insulation blanket or any other material.
Ø
Keep combustible objects and/or materials outside the appliance's radiation range. This radiation range is
500 mm, unless stated otherwise.
Ø
Only use the accompanying set, such as the wood or pebble set, and place it exactly as
described.
Ø
Leave space around the ionisation pin and spark electrode and never place glow material around these pins.
Ø
Make sure there is no dirt in gas pipes and connections.
Ø
Place a gas tap in accordance with applicable regulations.
Ø
Prior to putting into operation, check the complete installation for gastightness.
Ø
Prevent blocking of the explosion hatch(es) at the top and/or bottom of the appliance and check whether it/they
connect(s) properly to the sealing surface before the appliance is built in.
Ø
Do not ignite the appliance before the gas, discharge and electric connections have been fully installed, first
observe the procedure described in chapter 7.3.
Ø
Do not use the appliance when a pane is broken and/or cracked, until it has been replaced.
!Caution
In case of broken or torn glass panes, the appliance may not be used.
4