Dru Metro 130XTL RCH, Руководство по установке

Страница: 14 / 40

Eng
lish
INSTALLATION MANUAL
5.13 Placing the wood/pebble set
The appliance is supplied with a wood set or a pebble set.
The vermiculite that is used to fill the burner is black when using the wood set and has a natural colour when
using the pebble set.
!Caution
The figures do not always show the correct colours.
!Caution
Strictly observe the following instructions to prevent unsafe situations:
Ø
only ever use the supplied wood/pebble set;
Ø
only use the glow material (see appendix 3, fig. 23) in combination with the wood set;
Ø
place the wood/pebble set exactly as described;
Ø
make sure the ionization and spark electrodes and the surrounding space remain free
(see Appendix 3, fig. 17 up to 20);
Ø
make sure that the slot between the burner tray and the tray surrounding the burner is kept free from
objects;
Ø
make sure there is no vermiculite's dust on the burner.
5.13.1 Wood set
The wood set consists of vermiculite (see Appendix 3, fig. 21), chips (see Appendix 3, fig. 22), glow material
(see Appendix 3, fig. 23) and a number of branches (see Appendix 3, fig. 24).
!Caution
The figures do not always show the correct colours.
Ø
Remove the frame from the vermiculite tray (see Appendix 3, fig. 25).
Ø
Fill the burner with vermiculite; spread the vermiculite evenly (see Appendix 3, fig. 25). The vermiculite may not
come higher than the edge of the burner.
!Caution
• You can influence the flame picture by moving the vermiculite, yet
• the burner deck has to remain covered with vermiculite in order to prevent that the life span of the burner is
reduced.
Ø
Fill the vermiculite tray with chips; spread the chips evenly (see Appendix 3, fig. 25).
Ø
Identify branches A up to H (see Appendix 3, fig. 24).
!Tip Use the burn stains on the branches for identification.
Ø
Place branch A across the burner, place the ridge of the branch on the positioning bracket
(see Appendix 3, fig. 26a).
Ø
Proceed with branches B, C, D and E (see Appendix 3, fig. 26b).
Ø
Then place branches F up to H (see Appendix 3, fig 26c).
!Caution
The branches may not completely cover the burner pattern (see Appendix 3, fig. 27a + 27b), because:
•
the main burner will not ignite properly; which could result in unsafe situations;
• the appliance will become filthy more quickly, as a result of soot;
• the flame picture will be affected.
Ø
If required, spread the glow material over the burner.
!Caution
The areas around the ionization and ignition should remain free from glow material.
!Tip Fasten the glow material under chips and/or wood set.
14