DRESSTA TD-25M EXTRA, Руководство по обслуживанию, Страница: 533 / 595

SUSPENSION
SECTION 14
Page 39
DRESSTA TD-25M EXTRA
TRACK FRAME ALIGNMENT
51. TRACK FRAME ALIGNMENT (Fig. 14.43)
WARNING! Before working at the machine, be sure that the blade and ripper have
been lowered to the ground, engine is OFF, the drive train control lock lever is in
locked (ON) position and parking brake is set. The starting switch and the electrical
system master switch are turned OFF, keys are removed and the controls are
tagged to prevent inadvertent engine starting.
IMPORTANT: Disconnected hydraulic lines must be properly capped with the correct size plastic
cap. If caps are not available, use tape or rubber stoppers. Openings must never be plugged with
rags. This practice could introduce dirt or lint into critical hydraulic components. Remove all dirt
accumulation from the main frame cover. Tag disconnected lines to facilitate faster and correct
installation
.
Fig. 14.43. Track Frame Alignment
1. Sprocket
2. Pivot Shaft
3. Rear Top Idler 4. Front Top Idler
5. Guide Plate
6. Front Idler S1 – Pivot Shaft Shims
S2 – Guide Plate Shims
W, W1 - Gauge
W, W1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2140 [mm]
CHECKING ALIGNMENT
1. Operate machine on level terrain, stopping machine in forward direction.
2. Remove blade with push arm, refer to SECTION 17. Jack front and rear of machine up and
block it securely.
3. Measure distances at Y1 and Y2 inside edge of track roller (6, Fig. 14.44) outside flange to
outside edge of sprocket (7) on both sides of machine. Measure (W, Fig. 14.43) distance
between center line of sprockets and W1 distance between front idlers. These should both
check out to 2140 [mm].