A-17
TROUBLESHOOTING
WARNING: Always disconnect the power supply to the appliance before cleaning, doing
preventive maintenance or servicing.
WARNING: Contact the factory, the factory representative or a local service company to perform maintenance and repair.
Convection blower, draft inducer motor system are on the back and rack rotating system on the right side of the oven.
These components are sealed and don’t require lubrication.
Electric Control parts are located at the back, gas valve regulator on the right side behind the panel.
BEFORE CALLING FOR SERVICE ANSWERS TO MOST FREQUENT QUESTIONS
Questions
Solutions
The oven temperature drops when loading
and needs a certain amount of time before it
stabilizes.
This is normal. The opening of the door produces an important loss
of heat. The rack loaded with cold pastries need a large amount of
heat to get back to its original temperature. The same thing
happens with domestic ovens. You will realize that your new oven
can provide an excellent baking quality for any kind of products
you want to bake.
The oven does not turn on.
Check the breakers of the building.
Check the breaker on the back left corner panel.
Check if the door is tightly closed.
Inside the parts compartment, check if the breaker of the
convection blower is ON
The oven does not produce heat.
Make sure the thermostat is adjusted to a temperature high
enough to turn on the heat.
Check that the gas manual shut-off valve is open.
1. Check green pressure switch light on back right corner it should
be lite when draft inducer work.
2. If the oven blower is not on
Check the breaker behind the control door.
3. Check burner draft inducer if work.
4. If the control display heat system fault shut the main switch
OFF for 2 minutes and restart oven.
5. Check the LED blinking sequence on the ignition module.
Steady ON : replace module
1 blink: Air flow pressures switches issue, refer to point 1 & 3.
2 blink: flame ON without heat demand shut off gas valve call
gas technician.
3 blink: module Lockout shut off oven power for 10 second to
reset.
If it does not start up again, contact our company or a certified gas
technician.